Cold Formed Sheet Piles
The ESC-BP series is a cold formed sheet pile profile. The essential feautres of BP Profiles is the box-clutch interlock and its wide profile. The interlock provides good sealing capabilities.
The advantages of BP sheet piles include:
Clutch provides excellent annular area for joint sealing.
Interlocking clutches are located at the outer fibre.This results in an optimized section profile for high strength and low material weight.
High Moment of Inertia reducing deflection meeting serviceability requirements
Wider profile width reduces handling and installation time with usual driving equipment.
Wider profile reduces the number of interlocks required for a set wall run length, improving water-tightness capabilities
Section Modulus Range
BS EN 10249 Part 1 & 2
S235JR, S275JR, S355JR, S355JO
ASTM A572 Gr42, Gr50, Gr60
Q235B, Q345B, Q345C, Q390B, Q420B
Others available on request
Longer lengths can be spliced (>30m possible)
Any project specific length can be produced
By container (11.8m or less) or Break Bulk
Corrosion Protection Coatings
Due to the flexibility of the forming process, the ESC-BP Series Sheet Piles can be formed to almost any corner configuration, without requiring any wastage or welding. Note that the interlocks should be orientated toward the retained side as shown in the following figures.
All sheet piles, excluding the -S Series are class 2 or 3 for grade S355 and below.
BP-S Series sheet piles are class 3 for S275 and below in accordance to EN 1993-5:2007. Contact firstname.lastname@example.org if further detail is required